King and Pierce counties, Washington

The electrical and AV crew a Seattle-area custom home needs

A custom home in King or Pierce County needs more than one electrician. It needs line-voltage wiring, a low voltage prewire, AV and controls work, and sometimes security. Each of those is a different role, often with a different Washington certificate.

Hire for the work in front of you, not a generic title. Below are the roles a typical custom build uses, what each one does, what the market pays, what to check before the first day and where to look.

Start with the certificate, not the résumé

Washington certifies electricians statewide under RCW 19.28, and it’s unlawful to employ someone for electrical work without a certificate, a temporary permit or a training certificate. Workers carry the certificate and photo ID on the job. That makes the certificate type the first filter for every role on this list.

The ones you’ll see on a custom home:

Read the rules on the Washington L&I electrician licensing page, and verify each applicant’s certificate with L&I before you make an offer. For the full list, including the specialties a custom home rarely touches, see these Washington electrical license types. Washington has reciprocity only with Oregon, and only for the 01 general certificate. A strong applicant moving from another state may need time before they can work alone.

Role 1: Lead residential electrician

What they do. Service, panel, feeders, rough-in, trim and the final inspection. On a custom home they also coordinate with the AV and low voltage crew so boxes, conduit and power land where the integrator needs them.

Certificate. 02 residential at minimum. Hire an 01 general journey-level electrician if the same person also covers light commercial work or supervises 01 trainees.

Pay. Electricians in the Seattle–Tacoma–Bellevue metro earn a median of $48.93 an hour, with an annual mean of $99,720 (BLS, May 2025). That’s the market you’re competing in, and custom-home builders don’t get a discount for nicer job sites.

Role 2: Apprentices and helpers

What they do. Pull wire, set boxes, load material, keep the site clean and learn the lead’s habits. One good helper can free your lead to run two houses.

Certificate. A training certificate, always. Trainees on 01 general work must be in an approved Washington, Oregon or Montana apprenticeship, and training certificates renew with 48 hours of basic classroom instruction. Watch the supervision ratio before you add a second trainee to one electrician.

Pay. Electrician helpers in the Seattle metro earn a median of $36.59 an hour, with an annual mean of $74,540 (BLS, May 2025).

Role 3: Low voltage prewire technician

What they do. Run the structured cabling, speaker wire, control wiring, camera and alarm cable, and conduit pathways before drywall. They label everything and hand over a record the AV team can trust. A sloppy prewire costs more to fix than to do right.

Certificate. 06 limited energy, or a training certificate under an 06 holder. Sound systems, controls, intrusion alarms and fire signaling all sit inside the 06 scope.

Pay. BLS doesn’t publish a separate figure for prewire techs. The closest series, security and fire alarm systems installers, shows a Seattle-metro median of $36.50 an hour and an annual mean of $76,430 (BLS, May 2025).

Role 4: AV installer

What they do. Mount displays and speakers, build the equipment rack, terminate and test, then walk the owner through the system. On a high-end house they’re the person the homeowner remembers.

Certificate. Sound and control wiring fall under the 06 specialty, so an installer who pulls or terminates cable needs an 06 certificate or a training certificate. If the role only mounts and configures equipment, confirm the scope with L&I before you post it.

Pay. The wage data behind this article has no Seattle figure for AV technicians. Nationally, audio and video technicians earn a median of $27.93 an hour, with an annual mean of $64,630 (BLS, May 2025). Seattle electrical pay runs far above national figures (the metro electrician median above compares with $30.38 nationally), so budget accordingly.

Use this AV technician hiring guide to write the posting and the interview questions.

Role 5: Controls programmer

What they do. Program the lighting, shades, audio and climate interfaces, then keep the project files. This is often a contract or part-time role on a single house. Ask who owns the files at handoff before you sign anyone.

Certificate. Programming alone usually happens at a laptop. If the programmer also terminates control wiring on site, the 06 rules above apply.

Role 6: Security and alarm installer

What they do. Intrusion panels, cameras, access control and, where the house needs it, fire alarm devices.

Certificate. 06 limited energy. Remember that an 09 telecommunications certificate doesn’t cover this work.

Pay. Same series as the prewire tech: a Seattle-metro median of $36.50 an hour and an annual mean of $76,430 (BLS, May 2025).

Where to find each role

Leads and journey-level electricians. The general job sites (Indeed, LinkedIn) bring volume, but most of it won’t hold a Washington 01 or 02 certificate. The union hall is the route for union shops. Referrals from your supply house and other builders still work.

Apprentices. The Puget Sound Electrical JATC in Renton trains inside wiremen and runs a Limited Energy/Sound and Communication Technician apprenticeship under the 06 code. If you hire trainees, learn how its apprentices are dispatched and what the program expects from an employer.

Low voltage, AV and security techs. These people rarely search “electrician.” Post where electrical and low voltage people both look, and say “06 limited energy” in the title.

Best Electrician Jobs is a job board just for electrical and low voltage work, including AV and security techs. You post the job yourself and applications come straight to you. If you’d rather not run the search, use its electrician recruiting in Seattle. You tell a real person, Will, who you need. He checks the database and the people applying on the board, calls them about license, experience and travel, and you interview and decide. Sending the request costs nothing, and you get the price for your job before any work starts.

Hire in the order the house is built

  1. Lead electrician first. Everything else lands on their rough-in.
  2. Prewire tech before insulation. Missing that window means opening walls.
  3. Helpers once the lead has a schedule worth splitting.
  4. AV installer and controls programmer as trim approaches.
  5. Security installer to match the panel and camera schedule.

Write each posting for one role. Name the certificate, the house, the start date and the pay. People who hold the right Washington certificate skim for exactly those things.